Taurus MEGANE ACTIVE Manual De Instrucciones página 12

CARRY HANDLE/S:
- This appliance has a handle on the front part of
the body, which facilitates comfortable transpor-
tation (H).
PARKING POSITION:
- This appliance has its own parking position for
comfortable and straightforward storage.
- To make use of the horizontal parking hook the
head's hook onto the hook that is to be found on
the lower part of the appliance (Fig.3).
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust container after each use of the
vacuum cleaner.
- Disconnect the hose unit from the vacuum
cleaner, turn the connection to the left side and
pull out the hose. (Fig.2)
- Disconnect the dust box from the appliance
pressing the extraction button for deposit. (J)
(Fig. 4)
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig.5)
- Check the condition of the motor filter.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
- Fit the hose unit to the vacuum cleaners air in-
take and fix the hose turned to right side (Fig.1).
CHANGING THE FILTERS:
- Motor filter (Q), it is advisable to periodically
check the state of the filter, which should be
cleaned/replaced after every 50 hours of use.
- HEPA type air outlet filter (high efficiency air fil-
ter which effectively removes spores, ash, dust
mites, pollen ...), it is advisable to periodically
check the condition of the filter, it should be
cleaned/replaced after every 50 hours of use, or
if a significant drop in suction power is noticed
TO REMOVE THE FILTERS:
MOTOR FILTER:
- Disconnect the dust box from the appliance
pressing the extraction button for deposit. (J)
(Fig. 4)
- Open fixing part of the motor filter (R) that con-
tains the filter. (Fig. 6)
- Remove the filters: black foam filter (Q1) and
the microfiber filter (Q2) from its housing.
- (Fig. 7)
- Wash the black foam filter (Q1) under the tap
with clean water, scrub it like a sponge and let it
dry for 24 hours.
- Turn the microfiber filter (Q2) over and shake it
in the garbage can. If necessary, you can wash
it under the tap with lukewarm water and let it
dry 24 hours.
- Once they are completely dry place the filters
in the anchor, to fix the filters it is important to
place the fixation piece correctly: first it has to
fit through the two points (Fig. 8) and press the
other side until you hear two "clicks". (Fig.9)
- IMPORTANT: You can not place the tank until
the filter fixing part is not correctly placed.
OUTLET FILTER:
- Open the air outlet grille located on the back
of the vacuum cleaner. To access the filter
(Fig.10).
- Remove the filter (P) from its anchor (Fig 11).
- Turn the HEPA filter (P) over and shake it in
the garbage can. If necessary, you can wash it
under the tap with lukewarm water and let it dry
24 hours.
- Once they are completely dry, place the filters in
the anchor.
- To assemble the filter, proceed in the opposite
way to what was explained in the previous
section
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc...)
for your appliance model.
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist shops.