SUOMY X-WING Manual De Instrucciones página 17

PEAK — E—
F
EN
Adjusting — Figure 5
Loosen without removing the three screws on the right, left and
central part. Adjust the position of the peak (E) by rotating it upwards
F
or downwards until the desired position is obtained. After finding the
position, tighten the three screws and re-check the position of the
front part.
For all these operation, use the proper tool to tighten these screws.
E
F
E
F
F
F
F
FIGURE 5
Replacing — Figure 6
Loosen and remove the three screws placed on the t right, left and
central part. Position the new peak (E) by making the holes match F
E
with the three threaded fittings on the shell. Insert the screws in the
specific housings without tightening completely. Adjust the position
of the peak and lock it into position as indicated in above paragraph.
For all these operation, use the proper tool to tighten these screws.
FIGURE 6
19