Makita XDG01 Manual De Instrucciones página 7

CAUTION:
• Before installing the battery cartridge into the
tool, always check to see that the slide switch
actuates properly and returns to the "OFF"
position when the rear of the slide switch is
depressed.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the
front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
Indication lamp with multi function
1
► 1. Indication lamp
Indication lamps are located in two positions.
When the battery cartridge is inserted on the tool with the slide
switch positioned in the "O (OFF)" position, the indication lamp
flickers quickly for approximately one second. If it does not
flicker so, the battery cartridge or indication lamp is broken.
— Overload protection
— When the tool is overloaded, the indication
lamp lights up. When the load on the tool is
reduced, the lamp goes out.
— If the tool continues to be overloaded and the indi-
cation lamp continues to light up for approximately
two seconds, the tool stops. This prevents the
motor and its related parts from being damaged.
— In this case, to start the tool again, move the
slide switch to the "O (OFF)" position once
and then to the "I (ON)" position.
— Battery cartridge replacing signal
— When the remaining battery capacity gets low,
the indicator lamp lights up during operation
signaling that it is time to change the battery.
— Accidental re-start preventive function
— Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)" position,
the tool does not start. At this time, the lamp
flickers slowly and this shows that the acciden-
tal re-start preventive function is at work.
— To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing wheel point
1
2
3
4
► 1. Wrench 13 2. Wheel point 3. Collet nut
4. Wrench 13
Loosen the collet nut and insert the wheel point into the
collet nut. Use one wrench to hold the spindle and the
other one to tighten the collet nut securely.
The wheel point should not be mounted more than 10
mm (3/8") from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
To remove the wheel point, follow the installation proce-
dure in reverse.
10 mm (3/8") Max.
CAUTION:
• A 1/4" collet cone is provided as standard equip-
ment. Use an optional collet cone 1/8" to install
a 1/8" shank wheel point.
7 ENGLISH