Assembly - Baby Trend ST85 Manual De Instrucciones

ASSEMBlY

• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
upwards to access the seat (Fig. 4b).
ATTATChING ThE SEAT
5) • Make sure the seat fabric is properly
attached to the seat support bar. If the
seat fabric is unzipped, wrap the seat
fabric around the seat support bar
(Fig. 5a) and zip the fabric closed.
• Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and push
them together until they click securely
(Fig. 5b). The seat can face in either
direction, front or backwards.
7
7
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO AdJuST SEAT
6) • The seat can be adjusted into upright,
reclined, and carriage positions. Pull the
recline button on the rear of the seat and
rotate the seat into the desired position
(Fig. 6a).
• upright and Reclined Position: Buckle
the footrest and headrest straps on the
rear of the seat. Pull the excess straps
to tighten the seat (Fig. 6b).
Fig. 4b
• Carriage Position: Make sure both
footrest and headrest straps are
loosened and extend the seat surround
fully (Fig. 6b).
REMOvABlE CANOPY
7) • To attach the removable canopy:
Fig. 5a
Snap the canopy clips on the inside of
the toddler seat tubes (Fig. 7a).
• To open the canopy: push forward
on the front edge of the canopy while
holding the rear of canopy in place (Fig.
7b).
• To fold the canopy: pull backwards on
the front edge (Fig. 7b).
Fig. 5b
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBlY
Fig. 6a
Fig. 6b
Fig. 7a
Fig. 7b
8
8