Fantic INTEGRA 150 TRAIL Manual De Uso página 71

1. USING YOUR BICYCLE FOR
THE FIRST TIME
Before using your bicycle, read
the safety recommendation
booklet and this booklet.
The bicycle is shipped to the
dealer pre-assembled. Several
important safety components
are not assembled completely.
Your dealer must perform final
assembly of the bicycle; making
it safe.
Serious falls and accidents haz-
ard.
- Make sure that the vendor has compiled all the
sections of the test and inspection report be-
fore taking delivery of your bicycle (see section
"03" in the safety recommendation booklet).
- Use the bicycle only in a seated position adapt-
ed to your physical requirements.
- Adjust the height and position of the saddle
(see paragraph "3" - Section "04").
- Ask the vendor for instructions regarding tech-
nical devices installed on your bicycle.
- Make sure that the battery pack is fully charged
(see paragraph "3.b" - Section "06").
Ed. 1 - 07/2019
Checks and inspections
2. EACH TIME YOU USE YOUR
BICYCLE
An unsafe bicycle may result in
hazardous riding conditions,
falls and accidents.
- Before riding it, always check that your bicycle
is safe to use. It is important to bear in mind that
the bicycle may have fallen or been knocked
over, or been tampered with by strangers while
left unattended.
- Read that stated in paragraph "1.g" and "1.h" of
the safety recommendations booklet.
Visually inspect all the bicycle
components
breakages, deep cracks and any
other mechanical damage.
If you find any defects, contact
your vendor.
3. CHECKING WHEELS AND
TYRES
3.a - Checking wheel fastenings
- Check the wheels one at a time by attempting
to rock them from side to side while respecting
the direction of travel; the wheel unit locking
mechanism must remain stationary.
The release lever (1) must be closed (fig. "12").
There should be no squeaking or creaking.
03
for incisions,
EN_9