Fantic INTEGRA 150 TRAIL Manual De Uso página 86

Using power assisted pedalling
06
supply, after two hours, the battery charger
re-checks the state of the battery and, if neces-
sary, starts to recharge it again.
- The LEDs on the battery charger indicate its
current state (see table on the right).
Stand-by
Charging
Battery charged
Error
5. DISPLAY
5.a - Function buttons
T1. Display switching on/off (assisted pedalling
system ON/OFF)
T2. Lights switching on/off(if present and
connected)
- Short pressing: the light turns on.
- Longer pressing (more than 2 seconds):
the light turns off.
- In automatic mode: the light turns on and
off depending on the surrounding level of
light. It is possible to turn the light on or
off whenever it is desired by pressing this
button.
T3. Joystick
5.b - Display description
- The display offers a variety of information on
different pages.
Move the joystick laterally to pass from one
page to another.
Some pages offer additional pages to which
it is possible to access by moving the joystick
"T3" vertically.
- The main page offers the following
information:
EN_24
LED
green
red
green
blinking red
4. MOUNTING THE BATTERY
PACK ON ITS SUPPORT
- Insert the battery pack in its specific support
on the chassis by placing the rubber rod (1) on
the fork support (2) (fig. "59").
- Delicately push the battery pack downwards to
lay it in its specific support (fig. "60").
- Connect the connector to the battery pack (fig.
"61").
- Completely screw the fixing screw to lock the
battery (fig. "62" and "63").
T5
T1
T3
T2
T4
T4. Decreases the pedalling assistance level
T5. Increases the pedalling assistance level
Keep this button pressed for more than 3 sec-
onds to activate the push help function (max.
6km/h) until the button is released.
1
2
4
3
Ed. 1 - 07/2019