Technical Data - Oase NEPTUN 600 Instrucciones De Uso

Malfunction
Pump does not turn
on
Insufficient fountain
height
The pump turns off
after running for a
short time.

9. Technical data

Our specified capacities are always measured directly on the pump output (with-
out hose connection and accessories)
Neptun
Rated voltage
Power consumption
Liters per hour max.
Meter water column max.
Immersion depth
Cable length (indoor/outdoor)
Symbols on the nameplate:
2 m
Neptun Export.p65
GB Operating instructions
Cause
No mains power
Rotor is blocked
Regulator has been
excessively tightened
Filter housing is dirty
Rotor is dirty
Hose is blocked/defective
Feed line is kinked
Rotor is worn
Filter is clogged
Water temperature is too
high
V/Hz
W
l/h
m
m
m 1,5/10,0
The motor is dustproof and is protected against penetrating
water when submerged.
The motor is waterproof to a depth of 2 m.
CE symbol – this device fulfills the EU guidelines according to
the conformity declaration.
VDE tested (tested safety).
13
Remedy
Check mains voltage
Clean pump
Adjust regulator
Clean filter housing (section 6)
Clean pump (section 6)
Clean / replace hose
Check supply lines
Replace rotor
Clean filter (section 6)
Insure that the maximum water temperature
of +35°C is not exceeded
600 1000 1500
230 / 50
7 15
600 1000 1500
1,2 1,5
1,0 1,0
3,0/10,0 3,0/10,0
06.01.2004, 13:21
GB
2000
18 25
2000
1,8 2,0
1,0 1,0
3,0/10,0
13