Troubleshooting - IPC Absolute-C Manual De Instrucciones

Before performing any operation on the high pressure washer, disconnect it from the water supply and the mains
electricity supply (by turning off the omnipolar switch and unplugging it from the mains socket).
PROBLEM
When the start button is pressed, the
high pressure washer does not start.
No jet is produced.
The pump functions but does not reach
the rated pressure.
With the lance open, the pressure rises
and falls.
During the by-pass or total stop phases,
the high pressure washer stops.
After a by-pass phase, the high pressu-
re washer stops.
There is water in the oil.
Water leaks from the head.
During maintenance and/or repairs, use original spare parts only as these guarantee greater quality, reliable and
safety characteristics. Failure to use original spare parts absolves the manufacturer of all liability.
English

TROUBLESHOOTING

CAUSE
No electrical connection.
Thermal cutout has tripped.
The omnipolar switch is off.
Insufficient water pressure.
Incorrect connection to the mains water
supply.
Clogged water filter.
Mains tap closed.
Water supply filter clogged.
Incorrect connection to the mains water
supply.
Lance nozzle worn.
Valves dirty or worn.
Nozzle clogged or distorted.
Insufficient water supply.
Minor leaks of water from the high pres-
sure circuit.
The high pressure washer has been in
the by-pass phase for at least 3 min.
Oil seal rings worn.
Worn gaskets.
INFORMATION
- 24 -
REMEDY
Check the mains voltage (see technical
specifications).
Reset (if it trips again, consult a technical
service centre).
Reset (if it trips again, consult a technical
service centre).
Check the mains pressure.
Check.
Clean.
Aprirlo.
Clean.
Check.
Contact a technical service centre.
Contact a technical service centre.
Clean or contact a technical service
centre.
Check.
Contact a technical service centre.
Turn on again by pressing the start
button.
Contact a technical service centre.
Contact a technical service centre.