Technical Data; Maintenance; Fuse Replacement - Festo DIDACTIC Manual De Instrucciones

GB

7. TECHNICAL DATA

The reading accuracy for the individual inputs is:
(temperature coefficient: 0.2 x accuracy / C˚ at room temperature 18...28 ˚C)
No. Sensor type
1 Pressure
2 Temperature
3 Flow rate
4 Pressure
5 Pressure
6 Pressure
7 Pressure
8 Temperature
9 Temperature
10 Temperature
11 Vacant
12 Vacant
13 Vacant
14 Vacant
Display:
Temperature range:
Current supply:
Input impedance:
Dimensions:
Weight:
8.

MAINTENANCE

Changing the battery
If the battery requires changing, then 'BAT' ap-
pears on the Display. Use a 9 V standard battery
IEC6F22. The battery compartment is on the
rear side of the device.

Fuse replacement

The current input (SP2) is internally protected by
a fuse F0,1 A. When replacing the fuse, care
should be taken not to exceed the nominal value
of 100mA.
Sensor designation
HSP-100/10
HST-100/10
HSV
SDE10/10
SDE10/5
SDE10/10
SDE10/5
Si.Temp.Sens.
Pt 100
NiCr-Ni
Voltage 0...10 V
Voltage 0...10 V
Current 0...20 mA
Current 0...20 mA
4-digit LCD
0...50 ˚C
9 V standard battery IEC6F22, or regulated 24 V D.C. power supply unit
Input SP1: 1MOhm
172 mm x 77 mm x 25 mm
approx. 300 g
Range of values Accuracy
0...100 bar +/- (0,5% + 1Digit)
0...100 ˚C +/- (0,5% + 1Digit)
0...10 l/min +/- (2,0% + 1Digit)
0...10 bar +/- (0,5% + 1Digit)
0...10 bar +/- (0,5% + 1Digit)
0...10 bar +/- (0,5% + 1Digit)
0...10 bar +/- (0,5% + 1Digit)
0...200 ˚C +/- (0,5% + 1Digit)
0...200 ˚C +/- (0,5% + 1Digit)
0...100 ˚C +/- (1,0% + 1Digit)
+/- (0,5% + 1Digit)
+/- (0,5% + 1Digit)
+/- (0,5% + 1Digit)
+/- (0,5% + 1Digit)
- 19 -
Resolution
+/- 100 mbar
+/- 0,1 ˚C
+/- 0,01 l/min
+/- 10 mbar
+/- 10 mbar
+/- 10 mbar
+/- 10 mbar
+/- 0,5 ˚C
+/- 0,1 ˚C
+/- 0,1 ˚C