DeWalt DCD791 Manual De Instrucciones página 46

Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
To release the accessory, repeat steps 1 and 2 above.
Belt Hook and Bit Clip
(Optional Accessory) (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury,
ONLY use the tool's belt hook to hang the tool from a work
belt. DO NOT use the belt hook for tethering or securing the tool to
a person or object during use. DO NOT suspend tool overhead or
suspend objects from the belt hook.
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
CAUTION: To reduce the risk of personal injury or damage,
DO NOT use the belt hook to hang the drill while using as a
spotlight.
IMPORTANT: When attaching or replacing the belt hook or bit clip,
use only the screw (H) that is provided. Be sure to securely tighten
the screw.
The belt hook (G) and bit clip (I) can be attached to either side of
the tool using only the screw (H) provided, to accommodate left- or
right- handed users. If the hook or bit clip is not desired at all, it can
be removed from the tool.
To move belt hook or bit clip, remove the screw (H) that holds it in
place then reassemble on the opposite side. Be sure to securely
tighten the screw.
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 7)
NOTE: For best results,
make sure your battery
pack is fully charged.
To install the battery pack
(K) into the tool handle,
align the battery pack with
the rails inside the tool's
handle and slide it into
the handle until the battery
pack is firmly seated in the
tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (J)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Squeeze the tool trigger for three seconds to dissipate the slight
electric charge that may still be in the tool. The worklight may come
on for a brief moment.
FUEL GAUGE BATTERY PACKS (FIG. 8)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
44
FIG. 7
K
J