Cleaning And Care; Technical Data - Electrolux EKF3 Serie Instrucciones De Uso

822_949_368 EKF3030_Elux.book Seite 17 Freitag, 21. Dezember 2007 5:37 17
coffee one measuring spoon (approx.
6-7 g) is sufficient per cup.
0 Close the lid (figure 1/B).
0 Place the coffee jug complete with lid
onto the hotplate.
0 Switch on the appliance with the
ON/OFF switch (figure 1/E).
The pilot lamp lights up. After a few
seconds, hot water flows into the filter.
When the water has stopped flowing,
the appliance automatically switches
to the warming mode.
1 After use the appliance must be
switched off by hand.
0 Remove the jug.
Whilst boiling, the jug must not be
1
removed for longer than 30 seconds or
the filter will overflow.
Once the jug has been removed, the
filter valve prevents coffee from drip-
ping onto the hotplate. The hotplate
always keeps the coffee hot. It remains
on until the appliance is switched off
with the ON/OFF switch (figure 1/E)
and the pilot lamp goes out.
3 To guarantee uniform coffee strength
it should be stirred in the coffee jug
after preparation.
1 If the water has stopped flowing and
you wish to refill water for a fresh jug
of coffee, switch the appliance off and
allow it to cool down for a few minutes.

Cleaning and Care

Unplug the power cord from the mains
1
socket before cleaning.
0 To clean the filter holder, swing up the
handle and remove the filter holder
(figure 3).
To clean the filter valve thoroughly,
activate it several times whilst it is
being rinsed.
Reinsert filter holder and swing handle
down.
0 Clean the appliance with a damp cloth
but never immerse it in water!
3 Coffee jug and jug lid are dishwasher
proof.
Descaling - making your coffee
maker last longer
As a precautionary measure, we recom-
mend descaling every three months.
Only use an environmentally friendly
descaler and follow the instructions on
the packet. Please do not use a descaler
with a concentrated formic base, or
any descaler in powder form.
3 We recommend to use only original
decalcifying tabs from Electrolux
(PNC 900 195 537/7).
Fill the water reservoir with water and
only then add the descaler. Not vice
versa! Place the coffee jug with its lid
onto the hotplate. Allow the descaler to
take effect for about 15 minutes, then
switch the appliance on. Switch it off
when the descaler solution has finished
flowing through. If necessary repeat the
descaling process. Following this, allow
the appliance to run at least twice with
plain water. Thoroughly rinse the coffee
jug, lid and filter holder under running
water, activate the filter valve repeat-
edly during the rinse process.
Coffee jug
If your coffee jug smashed, you can
purchase a new one from your sales
dealer or the service centre specifying
the model of your coffee maker, see
rating plate (figure 1/H).

Technical Data

Mains voltage:
Power consumption:
; This appliance conforms with the fol-
lowing EC Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 89/336/EEC with
amendments 92/31/EEC and
93/68/EEC
g
220 – 240 V
915 - 1080 W
17