tau K580M Guía Para La Instalación página 17

photo-test error;
2 flashes:
Disable photo-test (dip-switch 6 OFF), check the operation of the photocells and their
connection;
5 flashes: no encoder signal (only with dip 11 ON);
Check wiring, check encoder by TEST-ENCODER (optional);
6 flashes: obstacle detected (only with dip 11 ON);
Make sure there are no obstacles across the path of the gate and that it slides smoothly;
Learning process not completed;
7 flashes:
Repeat the Learning process procedure;
Learning procedure in progress;
fast flashing:
fast flashing: Only when powered up: wrong power supply frequency (50 Hz default set-
ting);
(duration 30 sec.)
9. RESTORING AUTOMATIC OPERATION
Should the gate needs to be operated manually, use the release system. After a manual operation:
• after a power failure, such as a black-out (control board remains disconnected), before powering
the control board up again make sure the gate is either fully open or fully closed;
• after a Manual Operation without Power Failure (control board remains connected), before giving
any open or close command again, make sure the gate is either fully open or fully closed.
10. 433.92 MHz BUILT-IN RADIO RECEIVER
The radio receiver can learn up to a maximum of 30 rolling codes (BUG2R, BUG4R, K-SLIM-RP, T-4RP)
which can be set on both the two channels as desired.
The first channel directly commands the control board for opening the automatic device; the second
channel commands a relay for a N.O. dry contact (terminals 18 and 19, max. 24 Vac, 1 A).
LEARNING PROCEDURE FOR TRANSMITTERS
P1 = OPEN/CLOSE
P2 = 2nd channel
1_ press button P1 briefly to associate a transmitter with the OPEN/CLOSE function;
2_ LED DL8 turns off to indicate that the code learning mode has been activated (if no code is entered
within 10 seconds, the board exits the transmitters learning mode);
3_ press the desired channel of the transmitter to be memorized;
4_ the DL8 LED turns on to indicate saving is complete and then turn off immediately waiting for an-
other transmitter to be memorized (if this is not the case, try to re-transmit or wait 10 seconds and
restart from point 1);
5_ to memorise other transmitters, press the desired channel of the new transmitter within 2-3 sec
otherwise the learning procedure will be automatically closed and DL8 LED turns on. To repeat the
procedure to learn new remote controls start again from point 1 (up to a maximum of 30 transmit-
ters);
6_ to memorise codes on the 2nd channel, repeat the procedure from point 1 using button P2 instead
of P1;
7_ to exit manually the learning mode without memorising a code, press button P1 or P2 briefly.
Note: If the maximum number of codes is reached (30), the LED DL8 will begin to flash rapidly
for about 3 seconds without performing any memorisation.
REMOTE PROGRAMMING BY MEANS OF T-4RP and K-SLIM-RP (V 4.X)
With the new version of software V 4.X it is possible to carry out a remote self-learning of transmitters
T-4RP and K-SLIM-RP (new version V 4.X), without pressing the receiver's programming buttons.
It will be sufficient to have an already programmed transmitter on the receiver in order to start the
procedure of remote programming of the new transmitters. Follow the procedure written on the in-
structions of the transmitters T-4RP and K-SLIM-RP (V 4.X).
17