tau 300SA1 Guía Para La Instalación página 9

Detector de masa metálica
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

NUMBER OF TURNS OF WIRE IN THE SENSING LOOP
Perimeter of sensing loop
Perimeter of sensing loop
Perimeter of sensing loop
In the event two loops are set alongside each other, use 3 turns of wire in one and 4 in the
other to avoid possible crosstalk.
Please be advised that there should be no joints in the wire used for the loop.
POSITION OF DETECTION DEVICE AND INSTALLATION
Install the device in a watertight box.
The detection device must be installed as near to the sensing loop as possible.
LOOP DETECTOR SETUP
Select the functions on the 9-way DIP switch.
Turn on power: after 5 seconds, the unit will beep and the red DL1 status LED will start flash-
ing.
The device will beep for the first 10 detections
ON
Dip-
OFF
Switch 1
Sensitivity adjustment
OFF - OFF low
Dip-
ON - OFF
Switch
OFF - ON
2 - 3
ON - ON
ON
Dip-
Switch 4
OFF
Relay activation in PRESENCE MODE (set with DIP switch 8)
ON
Dip-
OFF
Switch 5
Relay activation in PULSE MODE (set with DIP switch 8)
ON
Dip-
Switch 6
OFF
< 7 m
7-10 m
> 10 m
high frequency (see "Crosstalk" chap. "
low frequency (see "Crosstalk" chap. "
medium low
medium high
high
detection boost option ACTIVE: when a truck is detected by the loop,
sensitivity is increased to its maximum level to detect trailers that are
high off the ground
detection boost option NOT ACTIVE
PERMANENT PRESENCE mode: the relay stays on for as long as the
vehicle is detected by the sensing loop. Once the vehicle leaves the
detection area, the relay goes off.
LIMITED PRESENCE mode: the relay activates when a vehicle is de-
tected and stays in this state for up to 30 min. If the vehicle fails to leave
the detection zone, a buzzer sounds after 25 minutes to indicate that
the relay will go off in another 5 min.
ACTIVATE ON EXIT mode: The relay activates when the vehicle (or
metal object) leaves the detection area.
ACTIVATE ON ENTRY mode: the relay activates when the vehicle (or
metal object) is detected.
P-300SA1
4 turns
3 turns
2 turns
Operating conditions"
Operating conditions"
GB
);
);
9

Publicidad

Tabla de contenido
loading

Productos relacionados para tau 300SA1

Este manual también es adecuado para:

Md 2010

Tabla de contenido