Caffitaly System F04MK Manual De Instrucciones página 9

The appliance has the "Froth and heat milk" (WHITE LED) and "Froth milk without
heating" (BLUE LED) buttons lit up at the same time, as shown in fi gure 1, when:
• Any button is pressed and the milk container is not in the base.
• Any button is pressed and there is no milk in the container.
• Any button is pressed and the mixer/frother insert is not inside the container.
• The milk container is removed from the base when the cycle has not fi nished.
IMPORTANT NOTE: To reset the alarm and return to operation status, press any
button TWICE.
• Place the appliance on a fl at surface.
• Remove the container from the base.
• Remove the lid and make sure the mixer/milk frother insert is inside the container.
• Fill the container with the recommended amount of milk, put back the lid and the
container inside the base.
Note: For better froth, use milk straight from the refrigerator (approx. 3°-5°C).
To prevent the milk from spilling after frothing, the maximum recommended amount of milk
(150ml) must not exceed the line mark MAX FROTH; this is because when frothed, milk
increases its initial volume.
• Insert the plug in a power socket. The appliance will beep.
• Press the button A; the other buttons go off . The milk frother will start rotating and
frothing the milk. When the required temperature is reached, the milk frother insert
stops; the appliance beeps and all the buttons light up.
Note: The cycle can be stopped in advance by pressing the button once. Do not remove the
milk container during operation.
• When the appliance stops, remove the container from the base and pour the hot frothed
milk (Fig.2).
• Always switch the appliance off by disconnecting it from the mains after use.
Note: It is advisable to clean the appliance of any milk residues after every use, to
avoid risks to health and prevent malfunctioning.
English
Alarms
Frothing and heating milk
9