Bushnell PRIME SP164850B Manual De Instrucciones página 3

WATERPROOF / FOGPROOF
Getting caught in a heavy downpour of rain with your spotter won't be a problem. The Prime spotting scope is manufactured
and tested to withstand water exposure to IPX7 standards. Fogproof protection is achieved from dry nitrogen purging that
removes all internal air, which can retain moisture.
All exterior lens surfaces have our new EXO Barrier™ coating (in addition to full multi-coating). EXO Barrier, quite simply,
is the best protective lens coating technology Bushnell has ever developed. Added at the end of the coating process, EXO
Barrier molecularly bonds to the lens and fills the microscopic pores in the glass. The result is an ultra-slick coating that repels
water, oil, fog, dust and debris - rain, snow, fingerprints and dirt will not stick. EXO Barrier is built to last: the bonded coating
will not fade with the passage of time or normal wear and tear.
USING THE TRIPOD / CAR WINDOW MOUNT (see below)
1. Unfold the legs fully and set the tripod on a stable, level surface such as a table or the ground.
2. Make sure the upper section of the tripod is level and securely attached to the top plate (a) of the lower section, by
tightening the C-clamp bolt (b).
3. Turn the mounting screw knob (c) to attach the scope's mounting base securely to the tripod platform (d) (do not
overtighten).
4. Twist the pan/tilt handle (e) counter-clockwise to loosen it, tilt the tripod head until the mounting platform is level with
the ground, then twist the handle clockwise to tighten it.
5. To tilt the scope vertically, twist the pan/tilt handle counter-clockwise to loosen it first, then tilt the tripod head up or
down. To pan the scope left or right, use the pan/tilt handle to rotate the tripod platform. To raise or lower the center
column, loosen the column lock (f), slide the column to the desired height, and re-tighten the column lock knob.
6. The top section of the tripod may also be used as a car window mount. Loosen the C-clamp bolt (b), and remove the
top section from the tripod plate. Roll down your window partially, leaving enough of it up to place the C-clamp on, with
the bolt knob facing you. Tighten the bolt knob to secure the mount in place, being careful not to cause damage to the
window (avoid using the mount on windows with significant curvature).
7. After installing the mount on the window, attach the scope to the tripod platform with the mounting screw (c). Loosen
and adjust the pan/tilt handle (e) to point the scope as needed, then tighten it.
b
d
c
a
f
Note: appearance and features
of tripod are subject to change.
e
Car Window Mount
(removed from tripod)
b
3