Arregui RESIST Manual De Instrucciones página 4

<EN>
Thank you for purchasing this RESIST safe. We advise
you to read the instructions before you install and use
the safe to prevent its improper use from making the
guarantee void.
A. CHARACTERISTICS OF THE PRODUCT
This safe is meant to protect your objects of value and
your documents in the event of a possible fire. Due
to its heavy weight, it is advisable to place it on firm
flooring.
FRONT DIAGRAM OF THE SAFE:
1
B. OPENING AND CLOSING THE SAFE
B.1. BATTERIES INSTALLATION AND OPENING
• Extract the battery compartment located outside the
safe, at the lower part of the keyboard, and place 4
alkaline batteries of 1.5 V.
• Press the * key. A beep sounds and a green LED
flashes.
• Enter opening code ( initial master-code is 1-2-3-4-
5-6)
• Every key pressing is confirmed with a beep sound
and a green led flashing. If the key is not pressed over
the course of 10 sec. the lock will switch off and the
operation must be repeated.
• Press ENTER
• While the green led is flashing, turn the key clockwise
and open the door.
• If the typed code is incorrect 2 beeps sounds and a
red LED flashes during 5 seconds. In this case, start
the operation again.
• The safe allows up to 3 erroneous code entries before
it is blocked for 5 minutes as a security measure.
During this time, it is not possible to use the keypad.
During the blocking period the red LED on the
keyboard flashes in 5 seconds intervals.
2
1. KEY.
2. NUMERIC KEYPAD
3. BATTERIES
COMPARTMENT
3
WARNING:
• For your own security, it is recommended to
change the opening code as soon as you open
the safe for the first time (see point C).
B.2. CLOSING
To close the safe, push the door and insert the key and
turn it towards left
C. PROGRAMMING OPENING CODES
This safe has 2 opening codes from 1 to 8 digits each
one: a master code and a user code.
WARNING:
• For your own security, it is recommended to change
the opening code while the safe door is open. If
you introduce a wrong number, you can press the *
key to delete it.
C.1. CHANGING MASTER CODE
• Press the * key + ENTER
• Press the 1 key + ENTER
• Enter the initial master code 123456 and press
ENTER
• Enter the new master code (4 digits minimum and 6
digits maximum) and press ENTER
• Repeat the new master code and press ENTER
C.2. PROGRAMMING USER CODE (using the
master-code)
• By default the safe is supplied with user code deac-
tivated.
• Press the * key + ENTER
• Press the 2 key + ENTER
• Enter the valid master-code (1-2-3-4-5-6 if original
one has not been changed in advance) and press
ENTER
• Enter the user code (4 digits minimum and 6 digits
maximum) and press ENTER.
• Repeat the user code and press ENTER