Product Characteristics - Peg-Perego PRIMO VIAGGIO Lounge Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
Thank you for choosing a Peg Perego
product.

Product characteristics

• Suitable for children between 40 and 87 cm with a
maximum weight of 13 kg.
• This is an Enhanced Infant Carrier Module to be used with an
i-Size base approved in accordance with UN Regulation No.
129. Suitable for seats compatible with i-Size, as indicated by
the car manufacturer in the use and maintenance booklet.
• Do not fit this car seat onto passenger seats which have
active airbags. Deactivate the airbag before fitting the car
seat. Using this car seat on seats with active airbags may
cause serious injury or death in the event of an accident.
• The use of the car seat for premature infants born at less
than 37 weeks could cause respiration problems for the
newborn. It is advisable to seek medical advice before
leaving the hospital.
• The car seat can only be used in approved vehicles, fitted
with static or inertia-reel three-point seatbelts, approved
under regulation UN No. 16 or equivalent standards. It must
not be used with two-point or lap seatbelts.
• When used with Base i-Size, this restraining system can be
fitted to vehicles with positions that have been approved
as ISOFIX positions (for more details, please refer to the user
manual), depending on the child seat category and the
structure.
• Consult the list of car models and seats equipped with
ISOFIX anchor systems (see inside) that have been approved
by the restraining system manufacturer.
Contact the restraining device manufacturer or retailer if you
have doubts or require further information on the fitting of
the Base i-Size in specific cars.
For more information, please contact the Peg Perego
Assistance Department at the address
assistenza@pegperego.com
• This car seat comes with "Adjustable Side Impact Protection":
improved protection against side impacts with the
"simultaneous system" for headrest-harness adjustment.
• This car seat is approved for installation in the car without
the base or with the Base i-Size.
WARNING
• Read the instructions carefully before use and keep
them in the holder provided for future reference. Failure
to closely follow the car seat installation instructions
will put your child at risk.
• The assembly and installation operations must be
conducted by adults.
• Always use a car seat when in the car. Never remove the
child from the car seat when the vehicle is in motion.
• Never leave a child alone and unsupervised in a car,
not even for a short time. The temperature inside the
vehicle can change rapidly and become dangerous for
the child inside.
• Install this car seat facing the direction opposite to the
direction of travel.
• Install this car seat only on seats facing the direction of
travel. If the vehicle has rotating or repositionable seats,
position them facing the direction of travel.
• Check that the child car seat is not blocked by a moving part
of the seat or a door.
• Scrupulously follow installation instructions; do not use
installation methods other than those recommended
because they could cause detachment of the car seat.
• Always use the harness when using this car seat.
• Adjust the height and tension of the shoulder straps
ensuring that they are snug to the child's body without
constricting him/her too much. Check that the harness is
not twisted and that the child does not release it.
• To avoid the risk of falling, always use the car seat harness
even for transport outside the vehicle.
• The car seat is not a substitute for a cot; if the child needs to
sleep it is important to lie him/her down.
• Do not use the child car seat if it is broken or if there are
missing parts, or if it has been subjected to heavy impacts
as a result of accidents, as it may have suffered structural
damage which is not visible but is extremely hazardous.
• Do not use the car seat without its fabric cover; this must
not be replaced with one not approved by the manufacturer
since it is an integral part of the car seat and the safety
system.
• Do not remove the white polystyrene part under the cover
and in the headrest as it is an integral part of the safety
devices.
• Do not leave the car seat in the vehicle when exposed to
the sun. Some parts might heat up and be harmful to the
delicate skin of the child -check before placing the child in
the seat.
• Do not modify the product.
• Do not remove the adhesive and stitched labels since
this might make the product non compliant with legal
requirements.
• For any repairs, replacement parts and information about
the product, contact the after-sales assistance service.
Contact information is provided on the last page of this
manual.
• Do not use accessories not approved by the manufacturer
or by the competent authorities.
• If using a second-hand product, make sure it is a recent
model, comes with instructions, and is fully functional
15

Publicidad

Tabla de contenido
loading

Tabla de contenido