Important - Agri-Fab 45-0326 Manual Del Usuario

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
10. (Figure 15) Insert the hopper pivot rod through the
upper hopper side tubes, the bag arm tubes and the
stitched sleeve at the front of the wind screen.
11. Using a hammer, assemble each palnut (S) onto one
end of the hopper pivot rod while bracing the other
end against a solid object.
12. (Figure 15) Assemble a vinyl cap (V) onto the end of
each bag arm tube.
VINYL CAP (V)
IMPORTANT: Do not over bend the support rods dur-
ing the following step. Over bending will cause the steel
rods to loose supporting tension.
13. (Figure 16) Tip the hopper onto it's back to assemble
the two hopper support rods. Place the ends of each
rod into the upper and lower rear hopper tubes,
bending the rod just enough to fit into the holes in the
tubes.
SUPPORT
RODS
ENGLISH
14. (Figure 17) Secure the rope to the top center of the
15
PALNUT (S)
HOPPER
PIVOT ROD
BAG ARM TUBE
15. (Figure 18) To assemble the hopper bag to the
16
9
www.mymowerparts.com
hopper bag frame.
sweeper, slide the ends of the bag arm tubes into the
ends of the sweeper's hitch tubes and secure with
two 1/4" x 1-3/4" clevis pins (R) and 3/32" hair cotter
pins (O).
BAG ARM TUBE
3/32" HAIR
COTTER PIN (O)
17
18
1/4" x 1-3/4"
CLEVIS PIN (R)