Charging Instructions - BS Charger BS 15 Manual De Instrucciones

CHARGING INSTRUCTIONS

STEP 1 - Pre Charge Check & Electrolyte Level Check
•
Check the Battery Electrolyte level (Not required on sealed & Maintenance Free Batteries). If necessary, remove the vent caps and
add distilled water so the levels are halfway between the upper and lower fill lines.
STEP 2 - Connecting the Battery charger to your Battery
• If the Battery is out of the vehicle:
-
Connect the Red lead from the charger to the positive (+) battery terminal.
-
Connect the Black lead from the charger to the negative (-) battery terminal.
Red
•
If Battery is still in the vehicle, determine if the vehicle is positively or negatively earthed.
-
If Negatively Earthed (Most Common) – FIRST Connect the Red (+) battery charger lead to the positive (+) Battery post and
then connect the Black (-) battery charger lead to the vehicle's chassis and away from the fuel line.
Red
Connection in vehicl e
(negativel y earthed)
-
If Positively Earthed – FIRST Connect the Black (-) battery charger lead to the Negative (-) battery post and then connect the
Red (+) battery charger lead to the Vehicle's chassis and far away from the fuel line.
Bl ack
Connection in vehicl e
(positivel y earthed)
STEP 3 - Connect the battery charger to Mains Power (230Vac)
• Connect the battery charger to a 230VAC Mains Powered socket.
•
The Charger will automatically start when AC power is connected and switched on.
(Note: If the Fault Indicator LED illuminates Red, please check your connections as it's likely that the Positive and Negative Leads
are reversed. Refer to Trouble Shooting Page for further information)
| www.bs-battery.com
BLACK
BLACK
Red
4