i.t.works SUNB1 Manual De Instrucciones página 9

After your weather station is powered up, it will take around 24 hours to become stable. The weathe
icons on the display give a reference to the next 6-12 hours weather conditions. It may not ma
the current weather condition outside.
Remarks: Moving your weather station fr
accur acy of your weather station, which should operate at the same altitude all the time. If you move
it to a new location, it will take 12-24 hours to stabilise and be accurate again.
Our weather station provides the next 12-24 hours weather forecast. It may not match with the
cur rent weather condition outside.
IF YOU LOSE THE OUTDOOR TEM
W hen the outdoor t mperature show "---": the wireless transmission has been interrupted or lost. e
Press and hold the
from the transmitter. If you continue to lose the outdoor temperature
and display, which could happen in extreme cold weather, try placing the transmitter in a different
location until you have smooth transmission of temperature data. Plea
displayed by pressing the
TROUBLESHOOTING
If y our weather station clock shows irrelevant i
discharge or interferences
weather station and also on the transmitter. Your unit will be reset to default settings and you will
need to set the time, calendar and alarm time again.
Problem
LCD is blank
No Outdoor Temperature
is displayed
Temperature, or air
pressure is incorrect
C ARE OF YOUR WEATHER ST
1. Do not expose the unit to extreme temperature, water or direct sunlight.
2. Avoid contact with any corrosive
3. Do not subject the unit to excessive force, dust or humidity.
4. Do not open the inner back case or tamper w
om one floor of a building to another floor will affect the
PERATURE.
/ CHANNEL button and your weather station will start to search for the signal
/ cannel button.
from other devices. Use a sharp object to press
Solution
1.
2.
1.
2.
3.
4.
1.
2.
ATION
nformation or digits, it maybe affected by electrostatic
Pr ess RESET on the main unit.
R eplace fresh batteries in your weather station.
Press and hold WAVE on the weath
Press and hold WAVE, then press RESET on the
transmitter.
Make sure the correct channel is selected on your
weather stati on (default setting is "CH1" – Channel
1)
Make sure no other interfering sources are being
used (such as computer monitors, TV sets,
headphones, or speakers) in the path of the signal
from the transmitter. The signal travels in a s
line; an electrical source near that "line" may cause
interference.
Press RESET on the main unit.
Make sure you r main unit and the transmitter is away
from sources of heat / cold / direct
materials.
ith any components of this unit.
EN.8
se check that channel 1 is
RESET on the top of the
er station.
traight
sunshine.
r
tch with