Health Hazard By Dust; Technical Data; Symbols; Use For Intended Purpose - Festool DOMINO DF 500 Manual De Instrucciones

e) When the motor unit is released, it must move back
actuated by spring force so that the jointer bit disap-
pears completely in the protective cover. If this does not
happen, the machine must be switched off immediately and
repaired before reuse.

Health hazard by dust

Various dust created by power sanding, sawing,
grinding, drilling and other construction activities contains
chemicals known (to the State of California) to cause cancer,
birth defects or other reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.

Technical data

Power
Speed (no load)
Jointing depth, max.:
Jointing width, max.:
Jointing bit diameter, max.:
Connecting thread of drive shaft
Weight (excluding cable
Degree of protection

Symbols

V Volts
A Amperes
Hz Hertz
~ Alternating current
n No load speed
0
Class II Construction
rpm Revolutions or reciprocation per minute
Ø Diameter

Use for intended purpose

The Domino dowel jointer is designed to produce Domino
dowelled joints in soft and hard wood, chip board, plywood
and fi bre boards. All applications beyond this are regarded as
unspecifi ed use.
The Domino dowel jointer is designed and approved for use by
trained persons or specialists.
The user is liable for damage and injury resulting
from incorrect usage!

Control elements

1.4 1.3
(1.1) ON/OFF switch
(1.2) Rotary switch for Domino dowel-hole width
(1.3) Unlocking device for motor unit / guide frame
(1.4) Auxiliary handle
(1.5) Clamping lever for angle guide
420 W
25 500 rpm
28 mm
23 mm + jointer bit
diameter
10 mm
M6 x 0.75
3.2 kg
/ II
1.2 1.1
1.8
1.7
1.6
1.5
The risk from these exposures varies, depending on how often
you do this type of work.
To reduce your exposure to these chemicals:
work in a well ventilated area, and work with
approved safety equipment, such as dust
masks that are specially designed to fi lter
out microscopic particles. Wash hands after
handling.
TO REDUCE THE RISK OF INJURY,
USER MUST READ AND UNDERSTAND INSTRUC-
TION MANUAL.
(1.6) Selection slide for material thickness
(1.7) Notch lever for Domino dowel-hole depth
(1.8) Notch lever lock
2.1
2.2
2.3
(2.1) Spindle lock
(2.2) Extraction nozzle
(2.3) Clamping lever for jointing height adjustment
(2.4) Stop pins

Power supply and start-up

The mains voltage must correspond to the speci-
fi cation on the rating plate.
Always switch the machine off before connecting
or disconnecting the mains lead!
See Fig. 3 for connection and disconnection of the power
cable.
3
To switch on, push the switch (4.1) forwards until it engages.
Pressing the back end of the switch is suffi cient to release the
switch-on lock and switch the machine off.
0 I
4.1
3
2.4
I O