B
Dosierkammer-Deckel
(Best.-Nr. 4009560) säubern. nschließend das Pumpenrad wieder einsetzen und mit Pumpendeckel schließen. Den Filter
wieder im quarium einsetzen und über den Netzstecker in Betrieb nehmen.
Power-LED-Lampe
a
1x Power-LED daylight & arctinic blue
e
2x Netzgerät mit Steckverbindung.
F Montage / Inbetriebnahme
A
Power-LED-Lampe
chtung: Pfeilrichtung beachten, da sonst keine Funktion.
B
d
Halterklemme
an der gewünschten Stelle am quarium positionieren, den Haltebügel
zudrehen.
C
Haltebügel über die Steckverbindung mit dem Netzgerät
schalter einschalten.
D
Wir empfehlen, die Lampe ca. 8 cm über der Wasseroberfläche zu installieren. So wird die optimale usleuchtung erreicht.
US
IMPORT NT S FETY INSTRUCTIONS
W RNING
To guard against injury, basic safety precautions should be observed, including the following.
RE D ND FOLLOW LL S FETY INSTRUCTIONS.
a )
D NGER
b )
To avoid possible electric shock, special care should be taken since water is employed in the use of
aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance to
an authorized service facility for service or discard the appliance.
1) If the appliance falls into the water,
nents of the appliance get wet, unplug the appliance immediately. (Non-immersible equipment only)
2) If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source.
(Immersible equipment only)
3) Carefully examine the appliance after installation. It should not be plugged
in if there is water on parts not intended to be wet.
4 ) Do not operate any appliance if it has a damaged cord or plug, or if it is
malfunctioning or has been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug or receptacle getting wet,
position aquarium stand and tank to one side of a wall-mounted recep-
tacle to prevent water from dripping onto the receptacle or plug.
"drip loop", shown in the figure, should be arranged by the user for
each cord connecting an aquarium appliance to a receptacle. The "drip
loop" is that part of the cord below the level of the receptacle, or the
connector if an extension cord is used, to prevent water traveling along
the cord and coming in contact with the receptacle.
If the plug or socket does get wet,
power to the appliance. Then unplug and examine for presence of water in the receptacle.
c) Close supervision is necessary when any appliance is used by or near children.
h
abnehmen, Dosierkammer
a
b
+
jeweils in den Haltebügel
DON'T
DON'T
g
, Pumpenkammer und usströmöffnung mit Reinigungsbürste
b
1x Power-LED arctinic blue
c
einklipsen und Lampe mittig ausrichten.
e
verbinden. Netzgerät einstecken und Power-LED mit Kipp-
reach for it! First unplug it and then retrieve it. If electrical compo-
unplug the cord. Disconnect the fuse or circuit breaker that supplies
3
c
d
2x Haltebügel
2x Halterklemme
c
einschieben und Halteklemme
PPLI NCE
POWER
SUPPLY
CORD
T NK
DRIP
LOOP
QU RIUM