Novellini Elysium Manual De Uso Y Mantenimiento página 12

ENGLISH
Description of remote control
Inserting/replacing the batteries:
Before inserting the batteries, make sure the power unit is
powered up.
The remote control takes ALKALINE AAA LR03 1.5V batteries
(supplied). When flat, they must be replaced with two new
batteries of the same type.
Insert the batteries respecting the polarity.
WARNING: it could be dangerous for
No
pace-maker wearer.
pacemakers
Before closing the door, make sure the water gasket is in
place.
Description of remote control:
After inserting the batteries, the remote control searches for
the sauna with which it must dialogue.
This is why the bath must be connected to the supply mains.
When this operation has been completed successfully (soon
after inserting the batteries), the remote control emits a beep.
Your remote control is now ready for use.
To optimise the life of the batteries, the display goes off 20
seconds after the last command. To turn it on again, lightly
press any point of the display.
Turning on:
Hold the display down until the introduction appears.
Main commands:
1
HYDROMASSAGE
3
DISINFECTION
5
ALL FUNCTIONS
OFF
Hydromassage menu:
To enter the hydromassage menu, press the 1 button in the
main menu.
9
NO OK
BACK TO THE
MAIN MENU
Selecting the desired hydromassage is done by pressing the
6-7 buttons repeatedly.
WHIRLPOOL
OFF
AIRPOOL
OFF
Press the 8 button to confirm and start the hydromassage.
To select the same hydromassage as that chosen last time,
pres the 8 button and the hydromassage will start.
If you want to change the hydromassage duration, enter the
Duration sub-menu by pressing the button 9.
Hydromassage duration sub-menu
By pressing the (+) and (-) buttons, the hydromassage
duration can be adjusted.
Once the desired time has been set, press the 10 button to
confirm.
To start the hydromassage, press the 8 button.
The screen displays the time remaining for the hydromassage,
and the 1 button is lit to show that the hydromassage is in
use.
NOTE: If the duration of the hydromassage is set to 0,
the hydromassage will stay on for about 1 hour from last
operation.
2
If water level in the bath is too low, the symbol 11 will
AUDIO
start flashing. In such a case fill the bath up with more water
FUNCTIONS
and the hydromassage will start automatically.
4
To prevent a quick decrease of water temperature, the bath
CROMOLIGHT
is equipped with a heater that is automatically started when
the Whirlpool hydromassage is on.
6
ALARM
6
7
8
MANUAL AUTOMATIC
TIMED
CONTINUOUS
10
-12-
11
Whirlpool sub-menu:
Whirlpool function can be selected by pressing the 6 button
more than once.
Whirlpool manual function:
By keeping the 6 button pressed, you can adjust the intensity
of the Whirlpool massage. When the button is released, the
desired value is set.
Whirlpool automatic function:
The intensity of the massage can be varied to have a pleasant
and modulating effect.
BACK TO THE
MAIN MENU
To go back to the main menu, press the Back to main menu
button.
Airpool sub-menu:
Airpool function can be selected by pressing the 7 button
more than once.
Audio menu:
To enter the audio source menu, press the 2 button in the
main menu.
7