dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 12

COMPACT 3.0
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
!
If the unit slants during assembly, wait for at least
60 minutes with the unit in horizontal position before
starting it up.
! Warning
In vehicles in which the electrical connection is made
to additional batteries which are independent from the
vehicle's start-up, the configuration of the electronics
to the new battery cut parameters is optional (see
page 19).
!
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Compact on roof, take into account that,
normally, cabins equipped with a hatch have a strong
enough structure to hold equipment weight. However,
if it is not the case and it is necessary to carry out a
cut in the roof or, although it has a hatch, the material
is not resistant enough (if roof is made of fibre, plastic,
etc...), it is the installer who will have to decide, under
his responsibility, if it is necessary to reinforce the roof to
avoid possible deformations, breaks, water entries, etc.,
habilitating the means required to stop it from occurring.
Warning
Warning
Torx wrenches set
Allen wrenches set
Open-jawed spanner 13
Scissors
Documentation included
Mounting instructions
User's guide
Troubleshooting
Parts list
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Equipment pre-charged with refrigerating gas,
R-134a. (Do not handle refrigerating gas circuit).
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
12
Tools
1001238893
1001247858
1001238883
1001238888
Symbology
! Warnings
®