Westinghouse LD-0003-07/WH/GS/55 Manual De Instrucciones página 6

INSTALL THE DOWN ROD
1) Feed down rod through ceiling canopy (No.3– Fig. 1) and bolt and pin cover (No.6– Fig. 1).
2) loose ball joint and insert the motor wires through down rod, and then secure ball joint back
to down rod.
3) Insert down rod (No.4– Fig. 1) to the top of the unit (No.8– Fig. 1), line up unit holes with down rod
holes and insert bolt (No.5– Fig. 1). Then insert pin (No.7– Fig. 1) to end of bolt.
4) Finally secure down rod and hanger via tightening two screws on the hanger.
INSTALL THE FAN TO MOUNTING BRACKET ON CEILING
1) Lift the fan to the ceiling and seat the ball joint in mounting bracket socket, make sure the tab on
the mounting bracket socket is properly seated in the groove in the ball joint.
2) Insert the remote receiver in mounting bracket (No.1- Fig.1).
3) Connect remote to motor wire via plugging the plug and socket together (No.2 - Fig. 3) , and connect
remote to mounting bracket via plugging the plug and socket together (No. 1 - Fig. 3).
4) Then slide the ceiling canopy (No.3– Fig. 1) onto the mounting bracket using the slotted holes. Align
the other 2 holes and then install the 2 other screws. Tighten all four screws firmly.
GS-78013-WH09
Adapter
Bolt
Top Housing
Figure 4
Male Plug
Lead Wires
Set Screw
Ceiling Canopy
Down Rod
Bolt & Pin Cover
Pin
Locking Screws
6