Aqua Medic EcoDrift Wireless Master Manual De Instrucciones página 4

Wireless control for EcoDrift current pumps of the x.1 series
In purchasing this controller, you have selected a top quality product. It has been specifically developed for
aquarium use and extensively tested by experts.
1. Scope of delivery
Electronic Safety Transformer - Input: 110 – 240 V / 50/60 Hz, Output: 24 V DC
•
Wireless control for EcoDrift current pumps of the x.1 series:
•
- Two separately or parallel controllable channels for connecting any number of current pumps of the series
EcoDrift x.1.
- The timer feature allows mutual alternating control of the channels in the interval of 1 - 60 minutes.
- Each channel can be individually adjusted for wave simulation, pulse rate and flow intensity.
- It is possible to reduce the flow at night automatically.
- Feed function for deactivating the flow for 10 minutes.
2. Safety instructions
- Read the instructions carefully before taking the unit into operation.
- Protect the controller from moisture, splash and condensate.
- Suitable for indoor use only. Do not expose to the weather or frost.
- Not suitable as a toy for children.
3. Operation
The EcoDrift Wireless Master Controller (Fig. 2) can only be used combined with the EcoDrift Control
0 - 10 V (Fig. 1). In case older pumps of the x.0 series are used, the controller has to be replaced.
Fig. 1: EcoDrift Control 0 - 10 V
1. Power input
2. Light sensor connection (at the side)
3. Pump connection
Available spare parts: Please refer to www.aqua-medic.de.
Valid for all controllers:
Connect the Wireless Controller Master to the transformer and power supply, it must remain permanently
connected. In case of a power failure, the settings are saved. By briefly pressing the "A/B LOCK" button, the
EcoDrift Control 0 – 10 V is directed to the requested channel A (yellow LED) or B (blue LED) for the respective
EcoDrift pump. All other settings are suspended then, the pump is only controlled by the EcoDrift Wireless Master
Controller.
Programs of the EcoDrift Wireless Master Controller:
20 - 100: Speed Mode: Flow of 20, 40, 60, 80 or 100% power. Only in conjunction with W1 and C.
MODE/NIGHT: By briefly pressing, the requested pump mode at each active channel is selected. By pressing a
bit longer, the night mode is reached (LED "Night" is lit).
4
Operation Manual ENG
Protect it from condensate and respect a
4. Control dial
5. Connection for 0 – 10 volt
maximum of 80% air humidity.