Cameo CLDROPP4 Manual De Usuario página 13

DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
SYSTEM SETTINGS (Settings)
Settings
Starting from main display 1, press MENU to enter the main menu. Using UP and DOWN, select the menu item Settings and confirm
System Info
with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
Menu
status with UP and DOWN, confirm with ENTER).
DMX Address
DMX Mode
Settings
DMX Delay
Stand Alone
Wireless = W-DMX settings
Slave
Settings
Settings
System Info
Display Reverse = Rotate display
Display = Display lighting
DMX Fail = Operating status with DMX
signal fault
Dimmer Curve = Dimmer curve
DimResp. = Dimmer response
LED Calibration = Color calibration
Auto Lock = Automatic locking of the
controls
IR Remote = Activate or deactivate con-
trol by IR remote control
Factory Reset = Reset to factory settings
Slave
01 - 06
W-DMX On/Off
Reset
On
Off
On
Off
Hold
Blackout
White
Linear
Exponential
Logarithmic
S-Curve
LED
Halogen
Red, Green, Blue,
White, Amber, UV
On
Off
On
Off
Reset Now?
On = W-DMX enabled
Off = W-DMX disabled
Press ENTER = Reset pairing with a transmitter and ready
for new pairing
Display is rotated through 180° (e.g. for overhead instal-
lation)
No display rotation
Permanently on
Deactivation after approximately 1 minute of inactivity
Last command is retained
Activates blackout
All the LEDs have 100% output
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX values
and broadly adjusted at higher DMX values
Light intensity can be broadly adjusted at lower DMX values
and finely adjusted at higher DMX values
Light intensity can be finely adjusted at lower and higher
DMX values and broadly adjusted at medium DMX values
Lamp responds abruptly to changes in DMX value
Spotlight behaves like a halogen spotlight with soft bright-
ness changes
Individual color calibration. Cross-mode brightness setting
of the 6 LED groups RGBWA+UV with values from 000–255
Automatic locking of the controls after approximately 1
minute of inactivity. Display shows: "LOCKED" To unlock:
press and hold UP and DOWN simultaneously for approx.
5 seconds
Automatic locking of the controls is disabled
IR remote control activated
IR remote control deactivated
Resetting to factory settings:
Perform reset with ENTER, cancel with MENU
13