Rubber Feet - Cameo CLDROPP4 Manual De Usuario

10
5 OLED DISPLAY
The OLED display shows the currently activated mode (main display 1), the spotlight status (main display 2 = W-DMX status), the menu
items in the editing menu and the numerical value or operating mode in certain menu items. Switch between both main displays by briefly
pressing ENTER and DOWN at the same time. The editing menu is accessible only from main display 1. If there is no input for approx. one
minute, the display automatically returns to the main display. Note on the main display in DMX operating mode: As soon as the control signal
is interrupted, the characters in the display begin to flash. When there is a control signal again, the flashing stops. Briefly pressing UP on the
control panel when in the main display rotates the display by 180°.
TOUCH-SENSITIVE CONTROLS
6
MENU – Press MENU to access the editing menu. Press repeatedly to go back to the main display. Pressing MENU without confirming a
value or status change with ENTER restores the previously confirmed value or status.
ENTER – Press ENTER to access the menu levels to make value changes and use the ENTER control field to access the submenus. Confirm
value or status changes by pressing ENTER.
UP and DOWN – select individual menu items in the selection menu (DMX address, operating mode etc.) and in the submenus. Allow chan-
ges to the value in a menu item, such as the DMX address, as required.
Before changing device settings, ensure that the control panel is dry and clean, in order not to impair its functionality.
7 TILT
Knurled screw for the TILT feature for uplighting. Turn the screw outwards from the housing until you achieve the desired beam direction.
The screw features a mechanical stop mechanism to prevent it from being completely removed from the housing. To be able to use the tilt
function effectively and achieve a more discreet look, remove the mounting bracket by loosening the four screws
8

RUBBER FEET

Four rubber feet on the underside of the spotlight ensure that it can be securely placed on suitable surfaces when used in uplight applica-
tions, while at the same time protecting the surface from scratches.
SECURING LUG
9
Securing lug for attaching the spotlight on truss installations. When installing on a truss, make sure that the mounting bracket is securely
attached to the spotlight housing using the four fixing screws
6
7
8
9
A
5
8
6
.
A
8
A
12
8
11
with a suitable tool.
A
10