Checking And Using The Meat Mincer; Electric Connection; Three-Phase Connection; End Of Day Cleaning - SAP TC Serie Manual De Instrucciones

________________________________

Electric connection

DANGER-CAutION: Electric connection to the power mains
should be executed by skilled engineers.
Check for the perfect efficiency of the plant grounding system. Make sure that the line voltage
(V) and the frequency (Hz) correspond to the machine ratings (refer to the machine identification
EN
plate and wiring diagram). The machine comes equipped with an electric cable to which a
multipolar plug should be connected. Plug the machine into a main wall switch with differential.

three-phase connection

Start the machine for just a few second and check that the beater turns in the right direction. If
this is not the case, disconnect power and exchange two of the three phase wires in the plug.

End of day cleaning

• At the end of the working day remove the plug from the power socket.
• Clean thoroughly using neutral products.
• Wash the outer part of the machine using a damp sponge.
• Do not use steel wool or abrasive pads.
• Dismantle the mincer set and wash using suitable detergents in hot water or in the dishwasher.

Long periods of inactivity

If the machine is to be left idle for long periods of time, turn off the main wall switch, thoroughly
clean the machine and cover it with a sheet to protect it from dust.

CHECkING AND usING tHE MEAt MINCER

- 22 - English language