Trouble Shooting; Disposal Of Cleaning And Servicing Substances; Technical Data - WALTHER PILOT SIL XXII Instrucciones De Servicio

8

Trouble shooting

Warning
Prior to any retooling the spray gun should be depressurized state, i. e. atomising air
as well as the material pressure - risk of injury.
Error Cause
Gun drips/sprays Air pressure too low
when not in use
Material hose too hard
Pulsating or shim- Material volume too low
ming
spray jet Wrong air cap position

Disposal of cleaning and servicing substances

9
Waste spraying media and waste material from cleaning and servicing must be dispo-
sed of in accordance with all applicable local and national regulations.
Warning
Observe the instructions issued by the manufacturers of the spraying and cleaning
material at all times.The improper disposal of waste material endangers the health of
human beings and animals!
9
Troubleshooting
Increase air pressure to at
least 2 bar
use softer hose
Fill in material
Adjust air cap position
10

Technical data

Net weight:
Material nozzles available:
Aircaps:
Pressure ranges:
Min. input air pressure
Max. input air pressure
Max. material pressure
Max. operating temperature
of the Spraygun:
Noise level
(measured at approx.
1 m from the spray gun):
Air consumption:
Atomising air pressure SIL XXII
2 bar 90 l/min
3 bar 130 l/min
4 bar 170 l/min
5 bar 200 l/min
6 bar 230 l/min
Right to effect technical changes reserved.
740 g
0,5 • 0,8 • 1,0 • 1,2 • 1,5 • 2,0 mm ø
Round-jet aircap V1010901053
(for material-nozzle sizes 0,5-1,5 mm)
Round-jet aircap V1010901203
(for material-nozzle sizes 2,0 mm)
2 bar
6 bar
2 bar
43°C
83 dB(A)
SIL XXIII
82,5 l/min
135 l/min
195 l/min
255 l/min
345 l/min
10