Assembly; Unfolding The Product - Joovy Tricycoo UL Manual De Instrucciones

Assembly

I WARNING:
to children under the age of 3 years – contains small parts prior to
assembly. Keep all small parts out of reach of children at all times.
IMPORTANT NOTE
Save the push handle cap and the Allen wrench for future use to convert the product for use by an older child.

Unfolding the Product

• Hold the product by the handle at the rear of the seat and stand the product upright on the floor. (1)
• Grasp the frame bar just above the right wheel and pull it slightly backward toward you. (2)
• Do the same for the left wheel frame bar. (3)
• Hold the push handle with one hand and with the other hand, push down on the bracket just below
the push handle. Push down all the way until it locks into position. (4)
• The locking lever just behind the push handle bracket should now be located in the UP position.
Push down on this lever until it clicks securely into its locked position. (5)
Ensure that this lever is locked into place securely.
• Lift up the front edge of the seatback/canopy/armbar assembly and raise it. (6)
• Lift up the front edge of the canopy and raise the canopy up so that it is in line with the seatback. (7)
• Lower the armbar forward into place. (8)
• If not already in position, lower the early stage footrests down into place. (9)
• Push the button at the top of the push handle and pull up slightly on the handle while at the same
time holding the lower tube. Release the button and continue pulling up until the push handle clicks
into place. (10) Note that there are two heights that you can adjust the push handle to.
• Attach the cup holder to the top of the push handle. (11)
Installing the Storage Bag
To attach the storage bag to the product, you must first remove the push handle.
• Stand behind the product and reach under the bottom of the push handle bracket to locate the
metal push button. (12)
• Push this button toward the front of the product while grasping and pulling the push handle
upwards out of this bracket. (13)
• Attach the loop at the bottom of the bag around the bottom of the push handle. (14)
• Reattach the push handle by orienting it with the cup holder facing the rear of the product and
inserting the push handle into its attachment hole. (15)
• Ensure the push handle clicks into place. You may need to twist it slightly to accomplish this.
• Pull up on the handle to ensure it is securely attached.
• Spread out the bag with the Joovy logo facing down on the floor. Attach one of the Velcro straps
to the frame bar just above the left wheel. (16)
• Attach the other Velcro strap to the frame bar just above the right wheel.
• Pull the open end of the bag up and attach the two loops at the top to the two posts on the push
handle. (17)
• Use the slider mechanism on the drawstring to close and open the bag.
You can detach the storage bag by following these steps in reverse order.
I WARNING:
allow children to play with or handle the storage bag. Do not load
the storage bag with more than 2 lbs. (0.9 kg). Excessive weight
may cause a hazardous or unstable condition.
6
Adult assembly required. Choking Hazard
STRANGULATION HAZARD: DO NOT