Fein ASW18-6 PC Manual Del Usuario página 27

OBJ_BUCH-0000000383-001.book Page 27 Tuesday, May 28, 2019 3:22 PM
Symbol, character Explanation
Apply retaining compound (medium tightness).
Allow retaining compound to cure according to the manufacturer's instructions.
24
(**) may contain numbers and letters
(Ax – Zx) Marking for internal purposes
Character Unit of measure-
ment, international
U
V
n
/min, min
0
r/min
n
/min, min
Reset
r/min
M...
Nm
kg
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
h
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
Hand-held screwdriver for screwing in and unscrewing
screws and nuts in weather-protected environments
without water supply using the application tools and
accessories recommended by FEIN.
Unit of measure-
ment, national
V
-1
, rpm, rpm
-1
, rpm, rpm
Nm
kg
dB
dB
dB
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
Explanation
DC voltage
No-load speed
(Range adjustable with Parameter Control soft-
ware (PC))
Speed (factory-set at delivery)
Torque
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value (screwdriving)
Basic and derived units of measurement from the
international system of units SI.
Special safety instructions.
Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may con-
tact hidden wiring. Fasteners contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Beware of any concealed electric cables, gas or water
conduits. Check the working area before commencing
work, e. g. with a metal detector.
Secure the work piece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
Hold the power tool firmly. High reaction torque can
briefly occur.
Do not work materials containing magnesium. Danger
of fire.
Do not work CFP (carbon-fiber-reinforced polymer) and
materials containing asbestos. These materials are con-
sidered carcinogenic.
Do not rivet or screw any name-plates or signs onto the
power tool. If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
en
27