Installation; Install The Batteries; Product Overview - HACH LANGE senslON Manual Del Usuario

This device complies with Part 15 of the FCC Rules and Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Warning - Unauthorized modification or changes to this wireless
communication equipment will void the right to use it. Changes or
modifications to this unit not expressly approved by the party responsible
for compliance will void the user's authority to operate the equipment.
Any change to the equipment will void the Industry Canada certification
and FCC grant.

Product overview

™
The sensION + series meters are used with sensION+ probes to
measure various parameters in water. Primarily for field use, the portable
meter operates on three AA batteries.
™
The sensION + series meters are available in 5 models:
™
• sensION + EC5 DL—conductivity, TDS, salinity and temperature
meter
™
• sensION + MM150 DL—pH, ORP (Redox), conductivity, TDS and
temperature meter
™
• sensION + MM110 DL—pH, ORP (Redox) and temperature meter
™
• sensION + pH1 DL—pH meter
™
• sensION + DO6 DL—dissolved oxygen (concentration and %
saturation) and temperature meter

Installation

Install the batteries

W A R N I N G
Explosion hazard. Incorrect battery installation can cause the release of explosive
gases. Be sure that the batteries are of the same approved chemical type and
are inserted in the correct orientation. Do not mix new and used batteries.
N O T I C E
The battery compartment is not waterproof. If the battery compartment becomes
wet, remove and dry the batteries and dry the interior of the compartment. Check
the battery contacts for corrosion and clean them if necessary.
N O T I C E
When using nickel metal hydride (NiMH) batteries, the battery icon will not
indicate a full charge after freshly charged batteries have been inserted (NiMH
batteries are 1.2 V versus 1.5 V for alkaline batteries). Even though the icon does
not indicate complete charge, 2300 mAH NiMH batteries will achieve 90% of
instrument operation lifetime (before recharge) versus new alkaline batteries.
N O T I C E
To avoid potential damage to the meter from battery leakage, remove the meter
batteries prior to extended periods of non-use.
The meter can be powered with AA alkaline or rechargeable NiMH
batteries. To conserve battery life, the meter will power off after
5 minutes of inactivity. This time can be changed in the Display Options
menu.
English 5