Testing Of The Appliance; Adjustments - Angelo Po 090FT1G Manual De Uso

4 - Remove the sticker from the nameplate and ap-
ply the new one to identify the gas being used.
Important
On completion of the operation, make sure
that there are no gas leaks or malfunctions.

TESTING OF THE APPLIANCE

Important
Before it is put into service, the system
must be tested to check the operating
conditions of every single component
and identify any malfunctions. In this
stage, it is important to check that all
health and safety requirements have
been complied with in full.
To test the system, make the following checks.
1 - Turn on the gas supply tap and check that the
connections are right.
IT 2 - Check that the mains gas is the same as that
used for commissioning of the appliance, and
carry out the conversion procedure if necessary
GB
(see page 21).
DE
FR
ES
RECOMMENDATIONS FOR ADJUSTMENTS
Important
Before making any type of adjustment, acti-
vate all the safety devices provided and de-
cide whether staff at work and those in the
vicinity should be informed. In particular,
turn off the gas supply tap and prevent ac-
cess to all devices which might cause unex-
pected health and safety hazards if turned
English
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.

ADJUSTMENTS

on. The gas valve is of "ON-OFF" type (with-
out minimum flame setting), so there is no
minimum flame injector.
The valve has a regulator cut-off device
which automatically ignites and cuts out the
burner on the basis of the temperature set.
- 22 -
3 - Check that the burner is switching on correctly
and its combustion.
4 - Check that the safety thermocouple is working
correctly.
5 - Check that there are no gas leaks.
6 - Check that the nameplates specify the correct
gas for the country of use.
IDM-3960200250.tif
8