ICA AQUA OCEAN Serie Manual De Instrucciones página 7

Install Your Wave Maker
Warnings
• The pump is suitable for aquarium thickness within 15mm.
• Do well connect the pump ,controller ,adaptor before plug in.
• Take care the magnet, as it is with Powerful Magnets and can cause Personal Injury.
• Protect the pump from falling.
• Don't align the magnet directly to the pump.
1. Remove the outer magnet from the magnet seat /sump ,place the pump upon the tank wall in your
pre-determined location . Take core to place the pump in a suitable location where corals are not
placed directly in the line of flow. Recommend a depth of 15cm under the water for your wave
maker location.
2. Put magnet to the outer tank wall a little far away from the pump, and then move the magnet slow
to align the pump.
3. Place the controller on the tank with adhesive tape or place on your pre-desired location.
4. Connect the pump with the controller ,adaptor and then plug in the power supply.
Fig.1
W-25 30% 100% SPEED
SPEED FEED
30% 100% FEED
M1 M2 M3 M4 MODE MODE
M1 M2 M3 M4 LOCK
LOCK
10min
LIGHT
Fast Slow Light Sensor 10min MODE
LIGHT
M1 M2 M3 M4 MODE
Fast Slow Light Sensor
M1 M2 M3 M4
Note
• Once you choose the location where you want to install the pump, clean
away any algae, calcified etc.
• Take core to place the pump in a suitable location where corals are not
placed directly in the line of flow.
• Controller ,adaptor are not water proof. Protect these components from
any contact with water.
Fig.2
OK
NO