Cleaning And Maintenance - Joyello POPI-POPI JL-980 Manual De Instrucciones

GB JL-980/981/982
NOTES:
The car safety belt must be pulled tight, making sure that it is not twisted
For GROUP I, the child seat MUST be positioned facing forward, in the direction of travel.
The child seat should be reclined to position "1", "2" or "3"
The airbag must be deactivated.
E) Once the child seat is attached to the car seat, loosen the harness by pulling on the harness
while pressing the harness adjuster button (FIG.32)
F To place the child in the seat, undo the harness by pressing the harness release button on the
buckle (FIG.33, FIG.34)
33
32
34
G) Position the child correctly in the seat (FIG.35)
H) Reconnect the harness to the buckle until it clicks into place. (FIG.36)
I) Adjust the harness to the right tightness for the child by pressing on the harness adjuster button
and pulling on the adjustment strap (FIG.37)
J) Make sure that the child is properly secured, that the buckle fastening mechanism is not pressing
on the child's stomach, that the harness is tight without causing discomfort and that the shoulder
pads are at the right height for the shoulders.
37
36
35

CLEANING AND MAINTENANCE

To remove the seat cover, you need to unhook the straps from the lower metal belt-yoke remove
the harness, detach the press studs on both sides of the seat, carefully remove the covering from
the top. To remove the cover for cleaning, you must release the shoulder straps from the yoke and
until the cords at the back of the child seat, pull these through to the front of the seat.
Unclip the studs on both rear sides on the seat. Carefully pull down the cover from the top.
Push the buckle and the buckle straps through the slots in the cover to release and pull it clear.
The cover is a safety feature. Never use the child seat without it, don't put your child's safety at risk
by using other replacement cover, they could stop the child seat from protecting your child as well
as it should. The cover is removable and washable at 30°C. The harness belt system and plastic
component can be washed by warm water.
• Cleaning of the cover: use only neutral detergent and wash with hot water. Do not machine wash.
Spinning cycle and dryer are not recommended.
20