Introduction; General Rules; Ambient Conditions; Meaning Of The Symbols - INE SKYLINE HFP3000 Manual De Instrucciones

INE SpA Via Facca, 10 - 35013 Cittadella - PADOVA - ITALIA Tel. 049/9481111 - Fax 049/9400249 - ine@ine.it - www.ine.it
1

Introduction

SKYLINE HFP inverter power source can be used for
MMA and TIG DC welding with Lift-Arc or HF start.
These power sources have been designed and
implemented on the base of the most updated and
innovative technologies conceived for inverters and
microprocessors in power electronics and signal
processing. Thus a system has been achieved that, in
addition to the traditional dependability of INE products,
is featuring high dynamics of the necessary control for
obtaining very good quality welding, together with a
more straightforward and easier use by the operator.
SKYLINE HFP welding machines are constructed
according to the following standards EN 60974:
•
as far as operators health prevention against electric
shocks is concerned.
•
as far as electromagnetic compatibility is concerned
(noise disturbing other
operating in the vicinity).
INE declines any liability should the welding machine
be used incorrectly (ex.: to defrost pipes, to charge
batteries, etc.) or modified by the customer or third
parties without any
manufacturer.
INE generators have been designed for professional
use and must be used exclusively by adequately
trained persons.
2

General rules

It is possible to work without risks only after
having fully read and understood the
operating and safety instructions, and of
course by complying with these strictly.
The safety rules/laws of the country where the
equipment is installed are to be observed.
This system is designed for welding steel, aluminium
and its alloys, as well as copper.
It is protected electronically against overloads. Don't
use fuses having a higher amperage than the one
specified in table "TECHNICAL DATA".
Always close any doors of the machine before you start
welding.
electrical appliances
written approval by
3

Ambient conditions

The system can withstand the following ambient air
temperature ranges:
When welding:
-10°C to +40°C (+14°F to +104°F)
During transport and storage:
-25°C to +55°C (-13°F to +131°F)
Humidity is not to exceed:
50% at +40°C (104°F)
90% at +20°C (68°F)
Welding, transport and storage are to be done within
such ranges. Trespassing them is to be regarded as a
violation. The producer will not be responsible for
damages caused by this.
The environmental air must be free of conductive dust,
corrosive gases, acids and other substances that may
damage the system.
4

Meaning of the symbols

the
Death or serious injury hazard!
Failure to comply with the safety precautions
can
consequences and even death.
Damage hazard!
Failure to comply with the instructions and/or
the safety precautions can cause damages
to the system and to the pieces being
machined.
Detach the power supply plug!
Disconnect the power supply plug before
operating inside the system.
i
Informative notes and indications for a
proper and facilitated use of the product.
Environment protection information.
Page 18
On the machine.
DANGER! Please read
instructions contained
manual.
cause accidents or
the
in the
severe