en
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
The light does not function.
Displays do not illuminate.
The temperature in
the freezer compartment is
too warm.
18
Possible cause
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Connect mains plug. Check whether the power
is on, check the fuses.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.