Selecting The Channel - Marmitek MEGAVIEW20 Manual De Instrucciones

system after the modulator the added audio/video signal can be watched
on the selected channel (see display).
Tips:
• Make sure the connectors are fitted properly to the coax cable.
• Use high frequency shielded connectors to prevent radiation and
interference.
• Use only broadband amplifiers and splitters with a range of 5-
1000 MHz.

5. SELECTING THE CHANNEL

The added Audio/Video-signal (of for instance a DVD-player or AV-camera)
is converted into a normal TV-channel.
With the MegaView20 you can actually choose every free channel. It is
important to choose a free channel, which is not yet in use by an existing
TV-channel. Which channels are free depends on the incoming antenna
signal. For this, consult the channel chart provided by your cable company,
or if you have your own antenna, the channel overview in your TV-guide.
1. Connect the power adapter to the modulator and plug this in the
socket. Turn on the modulator by switching the ON/OFF switch to ON.
2. Take your channel chart and look for two free adjacent channels. Then
you choose the higher of these two channels. Example: when channel
37 and 38 are free, you should choose channel 38. With three free
adjacent channels, you should choose the middle one.
3. Use the CHM and the CHL keys on top of the modulator to select the
chosen channel. The illuminated digital display on top of the panel
shows this channel.
4. Now switch on the desired A/V device (DVD, VCR, satellite receiver, PC,
camera, etc.).
5. Turn on the TV, and find the selected channel. How to do this can be read
in the manual of your TV. If you cannot select channels on your TV set,
MEGAVIEW20 7