Workpiece Support - DeWalt DC351 Manual De Instrucciones

CAUTION: Avoid contact with the blade teeth to prevent personal
injury.
CAUTION: Never engage the blade lock while saw is running or
engage in an effort to stop the tool. Never turn the saw on while the
blade lock is engaged. Serious damage to your saw will result.
1. Press the lock button (L).
2. Press the track saw down to stop (blade change position).
3. Turn the lock lever (M) clockwise until it stops.
4. Press the lock lever (M) down and rotate the blade until the lock
position is found.
FIG. 5
M
NOTE: The blade (K) is now locked and cannot be turned by
hand.
5. Turn the blade clamping screw (N) counterclockwise to
remove.
6. Remove the outer flange (O) and used blade (K). Place the new
blade on the inner flange (P).
L
7. Replace the outer flange (O) and blade clamping screw (N).
Turn the screw clockwise by hand.
CAUTION: The direction of rotation of the saw blade and the
rotation of the track saw MUST be the same.
8. Tighten the blade clamping screw firmly using the hex
wrench (S).
9. Turn the lock lever (M) counterclockwise until it stops.
10. Move the track saw back to top position.
11. Push plunge trigger (A) forward, to lock saw blade change.

Workpiece Support

WARNING: Hands should be kept away from cutting area to
reduce the risk of injury.
WARNING: The power cord should be positioned clear of the
cutting area so that it will not get caught or hung up on the work
and to prevent electric shock.
Figure 6 shows proper sawing position. Figure 7 shows an unsafe
condition. To avoid kickback, DO support board or panel NEAR the
cut. DON'T support board or panel away from the cut.
FIG. 6
SUPPORT WORK NEAR CUT
13
RIGHT