Electrical Connections - FALMEC CAPPE E-ION Manual De Instrucciones

D

ELECTRICAL CONNECTIONS

ATTENTION! Disconnect the appliance from the mains before performing any kind of opera-
tion inside the hood range.
Ensure that the wires inside the range hood are not disconnected or cut; if this is the case,
contact your nearest After-Sales Service. Electrical connections must be performed by quali-
fied personnel.
Connection must be performed in compliance with the standards in force.
Verify that the electrical system can support the load of the appliance (see technical data plate
in section B). The E-ION range hoods are usually supplied without plug and with power cable
with transparent sheath where the main insulation of the earth cable is yellow/green.
The appliance must be connected downstream a disconnection device conforming to the III
over-voltage category and national installation rules.
The yellow/green earth cable must be interrupted by the switch.
Before connecting the appliance to the mains, verify that:
- the power voltage corresponds to that indicated in the data plate.
- the earth socket is correct and functional.
- the power supply system has an efficient earth connection according to the standards in
force.
- the omnipolar socket or switch can be accessed easily with the appliance
installed.
The manufacturer declines any liability in the event safety standards are not complied with.
E
OPERATION
T: Timer key: pressing this key when the extractor fan is switched on will activate the shut-
down function after 15 minutes. Turn off the extractor fan and the light. The active function is
signalled with the red LED light flashing. The timer function, if activated, will be deactivated
when pressing the timer key again. The function is also deactivated when pressing the 0/1
key if the extractor fan has switched off. The key will light up permanently to signal, when the
extractor fan is switched off, to clean the aluminium filters after 30 hours of operation. Applying
prolonged pressure will reset the signal.
DEC: Deceive the automatic function is activated it will be deactivated. If the extractor fan is
in operation, it will reduce the speed and if the ioniser is activated it will reduce the power of
the ioniser.
0/1: If the automatic function is activated, it will be deactivated. If the extractor fan is switched
off, it will be activated to the first speed. If the extractor fan is in operation, it will be switched
off. With the extractor fan and the light switched off, applying prolonged pressure it will enable
the activation/deactivation of the ioniser. The ioniser has been activated if the Auto key lights
up during the prolonged pressure.
INC: If the automatic function is active it deactivates it. If the extractor fan is in operation,
pressing the key will increase the speed up to intensive and, if the ioniser is activate, it will
increase ionising power. The intensive has a 14 minute duration, after which time the extractor
13