Inglesina Gemino 1.2.3 Ifix Manual De Instrucciones página 17

7. Lastly, tighten the strap of the Top Tether system (4) until
the green signal is displayed on the indicator. The strap should go
over the backrest of the vehicle seat. If necessary lift the headrest
or remove it.
Caution! Make sure that the connectors are correctly fastened
into the anchor points of the vehicle by pulling the child car seat
once it has been installed.
To detach the child car seat follow the same steps in reverse.
8. Move the lever (12) to open the connectors and release the
anchors.
FROM 15 KG TO 36 KG
To install the child car seat, follow the steps explained above (1A
to 1D) without connecting the Top Tether (4).
There is also the possibility of installing the child car seat only
with the vehicle seat belt.
POSITIONING THE CHILD INTO THE CHILD SEAT
The car seat may be used for the following weight ranges:
9. 9-18 KG The child must be always secured using the child
car seat safety harness.
10. 15-36 KG The child car seat safety harness must be
stored away and the child must be secured with the vehicle
seat belt.
REMOVING THE SAFETY HARNESS
Once the child reaches a weight of 18 kg (105 cm tall approx) the
child car seat's safety harness should be stored away and the child
should be secured with the vehicle safety belt.
Follow the instruction on the shoulder label to detach and store
tha harness straps. Lift the seat fabric cover and store the crotch
buckle in the compartment. Then put the fabric cover back over
the seat.
USING THE CHILD CAR SEAT'S SAFETY HARNESS
(ONLY IN CONFIGURATION 9-18 KG)
11. Loose the harness by pressing the button and pulling the
tensioning strap (8).
12. To easily accomodate the child, unfasten the buckle by
pressing the red button then move both belt portions out
sideways.
13. Position the child in the child car seat and fasten the buckle.
14. Tight the harness by pulling the lower strap (8).
The harness is correctly tightened when it's possible to insert
a finger between the child's chest and the straps.
Make sure that the safety harness looks like in fig. 2A.
To get the child out of the child car seat follow the same process
in reverse.
15. Once the child reaches a weight of 18 kg the child car seat
adapts to its growth.
Pull upwards on the lever (2), slide the headrest (1) and the child
car seat will become wider to fit the baby size.
The child car seat's safey harness will move automatically without
any further action needed.
Make sure that once the child is positioned and the headrest is
17