EN
Features & Functions
Number Feature
1
Power supply
input
2
DMX input
3
DMX output
4
LED display
5
MENU buttons
6
Mic
7
PAR mounts
8
PAR connections
9
Light stand
socket
Function Setting
Using the four function buttons on the controller bar, you can set the operating mode of the unit. Press the Menu
button to display the different functions (see table below for a description of the functions). Set the UP or DOWN
arrow buttons to make your selection. When you have chosen your desired function, press the Enter button to
confirm the change.
Number
Display
1
D001-d512
2
IP.01-IP.64
3
A1.01
4
A2.01
5
A3.01
6
A4.01
7
A5.01
8
r.000-r.255
9
G.000-G.255
10
b.000-b.255
11
u.000-u.255
Connection of Signal Cable
You can use the 3-pin XLR cable to connect the OUT socket of the
first light and the IN socket of the following light. Connect all the
lights as shown:
Function
Attach the IEC mains lead here. Built-in fuse
3-pin XLR connector for DMX512 input communication
3-pin XLR connector for DMX512 output communication
LED function display and menu buttons to control the operating mode of the unit
MENU function buttons (see below for operation)
Built-in microphone for sound-controlled operation
Attach the PAR projectors to the controller bar at the 4 points shown
Connect the PAR projectors to the controller bar at the 4 points shown
Tighten screw to secure the controller bar to the light stand
Function
001-512
DMX address setting
001-512
IP mode
A1.01-A1.18
Static colour mode– press the Enter button to save
A2.01-A2.32
Jump change colour mode– press Enter to save
A3.01-A3.19
Multicolour mode – press Enter to save
A4.01-A4.19
Sound activated mode – press Enter to save
A5.01-A5.19
Strobe mode – press Enter to save
Adjust the red colour intensity up or down
Adjust the green colour intensity up or down
Adjust the blue colour intensity up or down
PAR white and PAR-ASTRO effects
3