Defrosting; Resolving Faults On Your Own; After-Sales Service; Guarantee - Haier LW-110R Instrucciones De Uso

English
To remove ice from the inner walls, use a plastic or
wood scraper without sharp edges.
Cover the frozen food with a cloth which aids to collect
the scraped ice and enables a simple removal.
13

Defrosting

Under normal conditions (3 to 4 openings per day) the
freezer must be defrosted once or twice a year (more
often in other cases).
Danger warnings
Never use electrical appliances to defrost the chest
freezer, e.g. hair dryer, fan heater, or devices with a
naked flame (e.g. candles).
Plastic in the inner compartment can melt and escaping
gas can be ignited by sparks or naked flames.
Proceed as follows:
1. Provide a suitable non-metallic container (plastic
container or wash-basket).
2. Make absolutely sure that you remove the plug
from the power socket.
3. Dry your hands thoroughly to prevent skin damage
by contact with ice (it is advisable to use gloves).
4. Remove all frozen food from the freezer, roll it
firmly in newspaper , put it into the container,
place the container in a cool, dry room.
5. Cover up the container all around with a thick
blanket.
6. Lift the divider ( not all models are equipped) upwards
upwards out of the guide-rail of the freezer.
7. Use the divider (so far as provided) as a defrosting
dish and push it on the side under the freezer –
where the defrosting water drain-plug is located.
8. Pull the plug (as far as provided) out of the freezer
bottom.
9. As previously described, scrape the thickest ice
carefully from the freezer inside and put it into the
kitchen sink. for defrosting.
10. If necessary, speed up defrosting by placing a
large pot of warm (not too hot) water on the freezer
bottom.
11. In freezers not provided with a drain-plug,
continuously wipe up the water with a sponge.
12. Thoroughly clean the inside (compartment).Rinse
it with a mixture of warm water and vinegar,
thereafter rinse with clear water.
13. Wipe the freezer
thoroughly dry and allow to air for about 3 to 4
minutes.
14. Replace the drain-plug (if provided)
15. Empty the dry defrosting water dish (if provided)
and slide it as divider into the guide rails of the
freezer.
16. Close the chest and plug it back into the socket.
17. Set the temperature control to maximum setting
(green and red lamps go on) and switch on the
SUPER FREEZE SWITCH ( if provided ) ( yellow
lamp lights additionally ).
18. Now refill the frozen food – the oldest items at the
top.
To prevent frosted food from defrosting, carry out steps
from 1 to 17 within max. two hours.
19. When the red lamp goes off, reset the temperature
control to a as per the filling capacity suitable
storage temperature.
with an absorbent cloth
Instruction for use
20. Switch off the SUPER FREEZER SWITCH (if
provided) after about 8 to 12 hours or, latest after
24 hours ( the yellow light goes off ).
14 Interior light
(not provided in all models)
A switch is built into appliances equipped with lighting.
When the appliance is opened the light goes on
automatically and switches off automatically when
closed.
The lamp is protected with a transparent cover.
Strictly use 15 W max.
15

Resolving faults on your own

High quality manufacturing processes and use of latest
cooling and freezing technology will principally ensure
trouble-free function of your appliance.
If you suspect any fault, before contacting the after-
sales service directly or via your dealer, make sure you
have observed all instructions and advice in this user
manual.
Repairs by the after-sales service, of faults that have
occurred because of non-adherence to the information
and advice given in this manual have to be charged to
the customer and are not covered by your dealer's

guarantee.

Attention
The compressor(also known as motor) must not operate
continuously.
It is controlled by the thermostat which you set with the
temperature control. It switches on automatically when
the set temperature in the storage compartment exceeds
and switches off automatically when the correct temperature
is reached again.
Noise can be heard in every compressor – cooling
system when the compressor is switched on. This noise
is produced when the motor in the compressor operates
and also by refrigerant flowing in the cooling system
circuit. These noises are normal and do not indicate
any functional trouble.
In unheated rooms and in cold weather condition
condensation can build up on the outer walls of the
appliance. This does not mean trouble and disappears
when the weather becomes warmer.
Calling the Customers Support Service
Call the after-sales service only, if after analysis of
possible trouble/fault factors you cannot find any cause
for the defect or do not have the means to eliminate the
trouble.
Therefore first check under "What is when ...."
16

After-sales service

Consult the enclosed guarantee card or the separately
enclosed after-sales centres list, to see which company
is responsible for servicing your appliance. If several
after-sales centres are mentioned on the list, select the
nearest one to you.
If no after-sales service centres list is enclosed with
your appliance, contact your dealer.
5