Squeegee Installation - Advance ecoflex SC2000 Instrucciones De Uso

Squeegee installation

1. Install the squeegee (A, Fig. 3) and fasten it to the bracket
(C) with the handwheels (B).
2. If necessary, adjust the squeegee with the knob (D) so that
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.
Washing water tank filling
1. Ensure that the washing water valve (9) is open (9-A).
2. To fill the washing water tank (15) remove the filler neck
plug (25).
3. Fill the tank (15) with clean water. If equipped, use the
water filler hose (optional) located in the filler neck (25).
Do not fill the tank completely, leave a few inches from the
edge. Use the level hose (16) as reference.
The water temperature must not exceed 40 °C.
EcoFlex™ detergent tank filling
WARNING!
When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
To handle floor cleaning detergents, wear suitable gloves and protections.
4. Lift the cover (18) and check that the recovery tank (17) is empty, otherwise empty it with the drain hose (26).
5. Close the cover (18).
6. Grasp the handle (35) and carefully lift the recovery tank assembly (17).
7. Fill the tank (38) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
NOTE
To accelerate filling of the hoses and system operation (with a new system, if the system has been emptied for cleaning,
etc.), it is a good idea to drain the EcoFlex™ system once or several times (see the procedure in the Maintenance
chapter).
01/2015
INSTRUCTIONS FOR USE
F
Figure 3
9100000386 - SC2000
ENGLISH
C
A
B
D
B
E
P100865
13