Safety: Use And Maintenance - Castellari FENIX V2 Manual De Uso Y Mantenimiento

The personnel shall:
-
always use the personal protection equipment required by law and follow the
instructions given in this manual,
-
observe all information / warning signs regarding machine-relevant dangers,
-
not carry out, on their own initiative, work on the machine that is outside the scope
of their duties,
-
inform their superior of any problems or danger situations that may arise.
-
The machine must only be used for the purpose for which it was designed.
-
The machine must not be run with the covers removed: safety guards/devices must
not be removed or disabled.
NOTE: Do not wear loose, flapping clothing as it could be caught up in the
moving parts of the machine. It is important to use suitable clothing. Workers
must not carry secateurs or sharp tools in pockets. It is forbidden to remain or
transit within the machine operating range.

2.3. Safety: use and maintenance

2.3.1. Safety: use
-
Before starting the machine make sure all safety devices / covers are in proper
working order.
-
The zone in which the machine is used is to be considered a "Danger zone" (i.e. a
zone in proximity to which the presence of an exposed person constitutes a risk to
the health and safety of that person). This rule is particularly important for persons
not trained to use the machine.
-
The area around the machine work zone must always be kept clean and free from
any obstructions. Make sure no persons or animals are in the area of machine
operation.
-
When a person is "exposed", that is, in a "danger zone", the operator must
immediately stop the machine and ensure that person leaves the danger zone.
-
When the machine is running, the worker must maintain a position that will allow
complete control of the machine so that appropriate action can be taken according
to circumstance.
-
Before leaving the machine unattended make sure the power supply is detached.
-
Periodically check the machine is in good working order, safety devices included.
2.3.2. Safety: maintenance
-
Before carrying out any work on the machine, make sure the power supply is
disconnected.
-
Maintenance tasks must always be carried out by personnel qualified for such
tasks.
-
At the end of maintenance/repair work the technician must make sure that the work
has been completed, the safety devices re-enabled and the covers re-fitted before
restarting the machine.
-
Use of appropriate personal protection equipment during maintenance/repair work
is compulsory. Such equipment includes:
Gloves
Castellari S.r.l. • Via Lasie 16/E
OLIVANCE PN - PNS - PN T - PN X - PN XT
OLIVANCE PN - PN S - PN T - PN X - PN XT
Hard hat
IMOLA (BO) 18
Castellari S.r.l. • • Via Lasie 16/E
Ear protection
• IMOLA (BO)
FENIX V2
FENIX
Anti-slip footwear
with steel toecaps
25