Maintenance - Jofel JET-SMART AA24050 Manual De Instalación

EN

5. MAINTENANCE

• Water tank full ( ). When the logo is ON it means that the wáter tank is almost full and must be
empty and cleaned. In order to do it, please follow instructions from point 6 CLEANING OF WATER
TANK.
• HEPA filter (1). It activates when suction is blocked or when HEPA filter is saturated. Hand dryer
will stop functioning; filter must be replaced.
To do so, remove filter cover, situated at the bottom of the device. It is fixed by means of two
screws, which can be unscrewed by inserting a coin or a flathead screwdriver into the slot and
rotating 90⁰. Cover will come off and then filter can be removed easily.
Fixing screws
HEPA filter cover
turn 90o
• Motor brushes (3). Notification of wear of motor brushes, they need to be replaced. After
replacement of brushes, please reset the motor counter following instructions included further in
this section.
• Jofel logo (blinking). It means that 30 seconds programmed drying cycle is finished. If sensors
detect a static object for longer than 30 seconds, the device will automatically stop.
• Heating element. If the device does not expel hot air when the LED diffuser light is red, then
there is a breakdown on the heating element. Wait for some minutes until device cools off. If the
problem persists, please contact Technical Support.
• Cleaning. Keep drain clean. Clean only with damp cloth. Do not use acid or bleach. Clean display
of IR sensors regularly.
Pag.10 JOFEL INDUSTRIAL S.A.
JET SMART HAND DRYER
C/ La Rioja nº3 Alicante, España www.jofel.com