Sensor Settings; About Security Settings - Nokia E73 Guia Del Usuario

To define which profile is activated when you attach an accessory to your device,
select the accessory and
To set the device to answer phone calls automatically after 5 seconds when an
accessory is attached, select
to Beep once or
To illuminate the device while it is attached to an accessory, select

Sensor settings

Select Menu Ctrl. panel
>
To set the device to silence an incoming call or snooze an alarm when you turn the
device face down, select
Security settings

About security settings

Select Menu Ctrl. panel
>
Avoid using codes that are similar to emergency numbers to prevent accidental
dialing of the emergency number. Codes are shown as asterisks. When you change
a code, enter the current code, then the new code twice.
Device and SIM card security
To change the PIN code, select
must be 4 to 8 digits long. The PIN code protects your SIM card against
unauthorized use and is provided with the SIM card. After three consecutive
incorrect PIN code entries, the code is blocked and you need to use the PUK code
to unblock it before you can use the SIM card again.
To set the keypad to lock automatically after a defined period, select
SIM card Keypad autolock
>
To set a time-out after which the device is automatically locked and can be used
only if the correct lock code is entered, select
autolock period. Enter a number for the time-out in minutes or select
set off the autolock period. When the device is locked, you can still answer
incoming calls, and calls may still be possible to the official emergency number
programed into your device.
To set a new lock code, select
code is 12345. Enter the current code and then the new code twice. The new code
© 2010 Nokia. All rights reserved.
Default profile.
Automatic answer
Silent in the selected profile, automatic answering is disabled.
Settings
>
Turning
Settings
>
Phone and SIM card
period.
Phone and SIM card
> On. If the ringing type is set
and General
control.
and General
Phone and SIM card
Lights
> Sensors.
> Security.
PIN code. The new code
>
>
Lock code. The preset lock
>
Settings
> On.
Phone and
Phone
None to
53