Getting Started; Load Paper - We R Memory Keepers TYPECAST Manual Del Propietário

GETTING STARTED

• Unpack machine and remove the transit safety devices.
1: Keyboard steel protection rod
2 & 3: Carriage track plastic stopper (two pcs)
4: Carriage return lever plastic stopper
4
2
• Raise Carriage Return Lever
in the down position. Always lift Carriage Return Lever into raised position when operating
typewriter.
• Typecast should be kept clean and free of dust. Occasional oil is recommended to keep
moving parts in smooth working condition.
ADJUST PAPER MARGINS
• Margin Stops
• Slide stops to the right and left to set paper margins. Margins determine at what point the
typewriter starts and stops.
• Margins can be overridden by pressing the Margin Override Key
SET LINE SPACING
• There are four setting which determine the line spacing of your typewriter.
R: No spacing. Carriage will move but paper will not advance upward.
1: Single spacing
-: One and a half spacing
2: Double spacing
• To set line spacing, move Line Spacing Selector
spacing.

LOAD PAPER

• Align left edge of paper with Paper Guide .
• Insert paper into Paper Insert Slot
• Turn either the Left Roller Knob
• Advance paper to top of transparent Alignment Guide .
• To align or straighten paper, release tension on Roller by pushing the Paper
Release Lever toward back of machine. Manually adjust paper using the transparent
Alignment Guide . Restore tension on roller by pulling Paper Release Lever
toward front of machine.
• Lift Paper Retention Bar
3
1
. Your typewriter will come with the Carriage Return Lever
are located near the back of the typewriter carriage.
until paper stops.
or Right Roller Knob
to raised position.
.
to correspond with the desired
to advance paper.