Extended Menu - Televes FI Simple Manual De Instrucciones

01030075_000:103422.QXD 22/07/2009
User manual
If you press again, you will be able to
access the configuration menu of the next
active processor (if it exists) and so up to 3
processors if the three of them are active
(the configuration menu of a processor will
only appear if it is activated).
PROCESSOR2
Fin:1450MHz
Fout:1400MHz
BW:36 Lev:99
After the configuration menu of the last acti-
ve processor, if you press the
will return to the start menu, that is, the first
configuration menu of the device.
CONFIG
P1: onP2: on
P3: on
LNB:00V
11:24 Página 44

5.2.- EXTENDED MENU

Both menu selection, modification of the
value selected on each extended menu and
and saving of modifications are done in the
same way than in the main menu.
You will access the first extended menu by
PROCESSOR3
pressing and hold (more than 3 seconds) the
Fin:1550MHz
Fout:1300MHz key = switch between main and exten-
BW:36 Lev:99
ded menus.
Both in main and extended menus, you will
change menus by pressing on
menu), following the sequence shown
again you
below:
a.- Configuration Menu
The first parameter that can be selected and
that appears within the extended menus in
this configuration menu is the RS-485
(change address of the device for the Headend
Control (CDC). All devices that can be con-
trolled via a headend control system are
connected to a common bus (on the con-
nector marked as "CTRL"). For a headend to
be controlled remotely, each controlable
element must have a unique address assig-
ned within the control common bus. The
range of addresses that are allowed is 001-
254.
It is the technicians responsability to
ensure that the addresses are not
duplicated in the control bus.
Press
modif , increasing or decreasing it with the
and
44
IF Processor
CONFIG
Adr CDC:001
to select the digit you want to
keys.